Study of the thickness of the silicon dioxide on wafer using dry and wet oxidation method

Study of the thickness of the silicon dioxide on wafer using dry and wet oxidation method

This final year project focused on four goals: to study the dry and wet oxidation thickness, to grow a thin layer of silicon dioxide (SiO2) on Si wafer, to determine the parameter required for thickness needed, and to compare with the simulation and theoretical thickness to achieve the most accurate...

Descrizione completa

Salvato in:

Dettagli Bibliografici
Autore principale:	Mohamad Fadzli Ali (Autore)
Natura:	Elettronico Software Database
Lingua:	English
Soggetti:	Microelectronics.
Tags:	Aggiungi Tag Nessun Tag, puoi essere il primo ad aggiungerne! !

Documenti analoghi

Reactive ion etching (RIE) etched wet-silica-on-silicon analysis for fluidwettability
di: Noor Aini Hamimah Abd. Rahim

Method of measurement of LTCC metallization thickness
di: Lee, Soo Khiang

Study of aspect ratio performance on silicon oxide etching using profiler meter, AFM and SEM
di: Nur Syuhada Md. Desa

Theoretical study, simulation & fabrication on dry oxidation in terms of Si02 layer thinckness, resistivity & surface roughness
di: Mohd Adam Alias

Study of the temperature effect on thickness and surface roughness of Si02
di: Mohd Azdi Asis

Optimization on oxidation process using 2K factorial design method
di: Yeap, Li Chain

Study of the effect of different gases parameter in dry etching process on etch rate profile
di: Zaharah Mohamad

Study on diffusivity of gallium dopant in silicon using spin on dopant (SOD) technique
di: Mohd Rosydi Zakaria

Thin polycrystalline silicon process development
di: Muniyati Pakhuruddin

Design and simulation of silicon-based magnetic sensor/
di: Nor Azlan Mohamed
Pubblicazione: (2011)

Study the effect of bird's beak on fully recessed locos and poly buffered locos using 2 different pad oxide
di: Hafizal Hafiz Sarjoni

Effect of different dielectric materials for ultrathin oxide
di: Zarimawaty Zailan

Investigation and modelling of boron diffusion reduction in silicon by fluorine implantation using numerical simulation
di: Chuah, Soo Kiet

The study on the effect of varing dopant concentration and diffusion time in the design of silicon avalanche diode with minimum VBR of 120+-20%
di: Yip, Siew Ling

Gate oxide interrity (GOI) characterization for deep submicron CMOS device
di: Norain Bt Mohd Saad

A study on surface roughness and morphology of Gallium Oxide Doped Ba0.5 Sr0.5 Ti03 thin film
di: Fadrul Hisham Mohd Fauzi

Optimization of nitride deposition process using Taguchi method
di: Low, Zen Shiang

Simulation of ion implantation using Monte Carlo method for investigation on ion trajectories
di: Zainab Ramli

Silicon wafer bonding technology : for VLSI and MEMS applications /
Pubblicazione: (2002)

Comparison of etching optimization process by taguchi method using minitab and design expert software
di: Azleen Abu Talib

Study of semi-recessed LOCOS for quasi-nanoscale CMOS devise isolation
di: Mohamad Idzham Abd Sani

Study and design the current mirror using bulk-driven technique for low voltage analog
di: Mohd Faidzul Bukhari Mohd Kanafiah

Study of deposition time influence the conical structure during electron beam induced deposition (EBID)
di: Mohamad Shahrizal Md Ilias

Study and design infrared beacon for the blind
di: Mohd Fadzlie Rasit

Study and improvement of UniMAP shower room
di: Lau, Iyu Pin

Comparison of Delays Between 4-Bits Ripple-Carry Adder And 4-Bits Carry Look-Ahead Adder Using Logical Effort Method/
di: Siti Nurhanani Che Yahya
Pubblicazione: (2011)

Study the basic infrared tx-rx circuit design for robot
di: Nik Ahmad Faiz Abdul Jamel

The study of the effect of MOS transistor scaling on the critical device parameters
di: Zazurina Abd Rahman

Study the effect of environmental noise on infrared Tx-Rx circuit signals
di: Mohd Zaihan Ibrahim

Automated classroom reservation using SMS
di: Nurul Nadiah Binti Mohamed Hatta
Pubblicazione: (2015)

Study in design of 32 x 4 bit static random access memory (SRAM)
di: Nor Bashariah Muhamad Bakhtiar

A Study of Proper Integrated Circuit (IC) Layout Techniques for a Parallel Adder/
di: Kau, Zee Shuang
Pubblicazione: (2011)

Student attendance management system using RFID
di: Nurul A'qilah Bt. Hasmizi
Pubblicazione: (2015)

The Design of an Encryption Chip Using Vigenere Cipher/
di: Tan, Shih Peng
Pubblicazione: (2011)

Portable phone directory using altera devices/
di: Vincent, Tiong Kwong
Pubblicazione: (2011)

Portable phone directory using altera devices/
di: Mohammad Isa Ahmad Azan
Pubblicazione: (2011)

The influence on the accelerating voltages on the growth of the square structure during electron beam induced deposition (EBID) method
di: Muhammad Afiq Abdul Aziz

A green house study of a capacitive soil moisture sensor for loamy clay soil
di: Nur Umirah Binti Johari
Pubblicazione: (2015)

Study of acceleratin voltage influence the conical structure during electron beam induced depasition (EBID)
di: Muhammad Afif Abdul Rahman

Smart arm robot using visual basic program
di: Wee, Joo Ann