Study the effect of environmental noise on infrared Tx-Rx circuit signals

Study the effect of environmental noise on infrared Tx-Rx circuit signals

This final year project is about the environmental noise effecting infrared transmitter and receiver (TX-RX) circuit signal. Efforts on environmental noise reduction are also proposed. To improve the noise immunity against ambient light, the optical noises from the fluorescent lamp are analyzed and...

Descripció completa

Guardat en:

Dades bibliogràfiques
Autor principal:	Mohd Zaihan Ibrahim (Autor)
Format:	Electrònic Software Base de dades
Idioma:	English
Matèries:	Microelectronics.
Etiquetes:	Afegir etiqueta Sense etiquetes, Sigues el primer a etiquetar aquest registre!

Ítems similars

Study the basic infrared tx-rx circuit design for robot
per: Nik Ahmad Faiz Abdul Jamel

Development of capacitive instrument based on PIC16F876 microcontroller, RF-TX-315 and RF-RX-315 radio frequency modules for measuring loamy clay soil moisture content
per: Siti Nur Atiqah Binti Saharuddin
Publicat: (2015)

Study and design infrared beacon for the blind
per: Mohd Fadzlie Rasit

Modeling of far-infrared spectoscopy for first order semi-infinite ferroelectric
per: Mohd Zafiri Mohd Nor

Investigation of far-infrared (FIR) optical behaviors in ferroelectric (FE)-semiconductor film
per: Ramli Abdul Wahab

Study of the temperature effect on thickness and surface roughness of Si02
per: Mohd Azdi Asis

Design of control circuit for an inverter
per: Nurfaiza Hanim Mohd Saleh

The study of the effect of MOS transistor scaling on the critical device parameters
per: Zazurina Abd Rahman

Microelectronic circuits and devices /
per: Horenstein, Mark N.
Publicat: (1996)

Design a Wideband low-noise amplifier for wireless communication using 0.35-¡Łm CMOS technology
per: Mohd Hafiz Abu

A Study of Proper Integrated Circuit (IC) Layout Techniques for a Parallel Adder/
per: Kau, Zee Shuang
Publicat: (2011)

Electronic devices & circuits - II /
per: Godse, Atul P.
Publicat: (2008)

Study of the effect of different gases parameter in dry etching process on etch rate profile
per: Zaharah Mohamad

Analysis the role of supply voltage and load capacitor in small-signal mosfet amplifiers
per: Mohd Iskandar Jalaludin

Semiconductor optical amplifier (SOA) for photonic signal processing/
per: Latty Shazana Ismail
Publicat: (2011)

CMOS Inverter-Circuit Characterization and Performance Estimation/
per: Chew, Chee Ting
Publicat: (2013)

Design and Analysis of a Sensor Interface Circuit/
per: Ahmad Samier Farhan Suhaimi
Publicat: (2011)

Microelectronic circuits and devices
per: Horenstein, Mark N.
Publicat: (1996)

Microelectronic circuits and devices
per: Horenstein, Mark N.
Publicat: (1996)

Heart beat sensor circuit for anti - stress chair
per: Farah Athirah Jamal Mohamad
Publicat: (2015)

Design and Analysis of a Digital Signal Processing for Biomedical Application System/
per: Ch'ng, Ei Peng
Publicat: (2011)

The study on the effect of varing dopant concentration and diffusion time in the design of silicon avalanche diode with minimum VBR of 120+-20%
per: Yip, Siew Ling

Study the effect of bird's beak on fully recessed locos and poly buffered locos using 2 different pad oxide
per: Hafizal Hafiz Sarjoni

Design of tool kot for active filter circuit pc-based
per: Muhammad Firdaus Mad Isa

Logical Effort of CMOS 4-2 Compressors for Arithmetic Circuits/
per: Wong, Liang Yuan
Publicat: (2011)

Effect of different dielectric materials for ultrathin oxide
per: Zarimawaty Zailan

Simulation on effect of different types of channel/ drain engineering structure on MOS device performance
per: Norazlina Mohd Amin

Study and design the current mirror using bulk-driven technique for low voltage analog
per: Mohd Faidzul Bukhari Mohd Kanafiah

Study on diffusivity of gallium dopant in silicon using spin on dopant (SOD) technique
per: Mohd Rosydi Zakaria

Study and improvement of UniMAP shower room
per: Lau, Iyu Pin

The effect of power density on the surface layer of amorphous thin film
per: Ahmad Fadzil Izaharuddin

Effect of diffusion coefficient and junction depth on variation of temperature and energy
per: Nur Ruzana Bohari

Theoretical study, simulation & fabrication on dry oxidation in terms of Si02 layer thinckness, resistivity & surface roughness
per: Mohd Adam Alias

Polysilicon process development - the effect of pecvd process parameters on the film characteristics
per: Mujahidun Mashuri

The effect of process parameters on metal step coverage for aluminum (AI) by evaporation technique
per: Noraishah Azman

Study of semi-recessed LOCOS for quasi-nanoscale CMOS devise isolation
per: Mohamad Idzham Abd Sani

A study on surface roughness and morphology of Gallium Oxide Doped Ba0.5 Sr0.5 Ti03 thin film
per: Fadrul Hisham Mohd Fauzi

Study of the thickness of the silicon dioxide on wafer using dry and wet oxidation method
per: Mohamad Fadzli Ali

Coherent effect on LOCOS and STI technique for 0.18℗æm CMOS technology using taurus workbench
per: Wan Shafie Wan Sulaiman

Study in design of 32 x 4 bit static random access memory (SRAM)
per: Nor Bashariah Muhamad Bakhtiar